Brother PR6 Embroidery Machine Service & Repairs
All Work Guaranteed
Brother PR6 Service and Repair
It's important to maintain your Brother PR600, PR620, PR650, PR655, PR670e, PR1000 and PR1050x to keep it working well. You should always keep an eye on the embroidery hours listed on your PR. Remember, all Brother PR models should be serviced every 500 hours of use.
Brother PR6 Service CostsOur charge for a full 500 hour service starts at £269.00 this price excludes parts and VAT. Any additional parts we require will be charged as extra but we will consult with you first. It's always a good idea to contact us by email or phone in advance to book your PR in for a service. Our workshop is always a busy place and most of the work we do is either in a queue or has been booked in advance.
Once your PR is in our workshop and on one of the benches we will always phone with a free and exact estimate of the cost for service or repair.
After spending so much on your Brother PR model, the cautious owner will be careful where they take their PR for any service or repair work. Bambers have a long standing reputation for top quality service and repair work on the Brother embroidery machine range. We are also main agents for Bernina & Janome machines.
During its time with us your can be assured that your PR will be treated with care and respect and it will go through a very comprehensive list of checks and tests.
Here is a copy of the service checks every Brother PR model goes through during our workshop service.
- Check Hours
- Check Plug & Fuse
- Check Cable Integrity
- Remove all Covers
- Remove Thread Guide Base
- Remove X/Y Feed Carriage
- Remove Arm Bed from Base Frame
- Lubricate/Replace Idle Pulley Shaft Gear
- Remove Tension Base Platform
- Strip Tension Units & Replace Felts
- Strip & Clean Pre-tensions & Check Springs
- Check 6 Check Springs in Thread Tension Units
- Lubricate Machine
- Replace Fixed Knife & Presser
- Check Movable Knife Condition & Adjust
- Base Rubbers
- Main Motor Check
- Drive Belt Check
- X Drive Belt Check
- Y Drive Belt Check
- Check Take-up Lever Drivinbg Arm Play in Cam
- Replace Needles
- Check Needle Threader
- Check Thread Presser Base Velcro Condition
- Check X - Y Position Zero
- Check Shuttle Timimg
- Check Needle to Hook Gap
- Check Picker Position
- Presser Foot Height
- Check Hoop Sensor Adjustment
- Check Sensors
- Zero Service Time
- Check 'O' Rings
- Clean Covers & Refit
- Test Sew
Write a review and let shoppers know what you think of this product.
I have had 4 of my PR embroidery machines serviced by Bambers recently. Collection of each machine, by Steve Bamber, within a day I had a call from the actual guy who was going to service each machine - a full run down of what was going to be done and what was going to be replaced. I accepted the quote for each machine. All 4 machines are back with me now running very smooth (3 in fact sound better than as new condition) 4th is better than before service but showing signs of age. Each piece of machine replaced - I got the old part in a bag to show me the wear and a chat as to how it happened... I will only use Bambers again, no hesitation 4 machines serviced - no problems! Thank you Bamber Guys!